Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem a little old, but it is still striking. It's not the most luxurious car in its class but the Ford Focus or Volkswagen Golf will isolate you even better from imperfections on the road - but it's a relaxed and civilised driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fob s. If the issue is ongoing or continuous the following tips will aid.
Water Damage
If you accidentally drop your key fob in the puddle, or it gets wet while kayaking, canoeing, rafting or canyoning it is likely to be damaged by water. The best way to stop this from happening is to always keep it in a dry, dry bag when you're outdoors or performing activities that require the fob to be exposed to excessive amounts of water.
You'll also want to ensure that the fob is dry prior to opening it and re-using it. If you notice any odors emanating from the fob like an industrial liquid smell or the scent of windshield washer fluid, this is another sign that it's been submerged in water.
A circuit board that is wet could cause the battery's charge to drop its charge, or even explode. If you're able to fish your 308 key fob out of the water in which it was stuck in turn the button upside down and shake it out as much water as possible before opening the case. Remove the battery, then wipe the circuit board clean using a cotton swab which has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system could fail to function include a dead coin battery problems with the receiver module, signal interference, or an electronic chip that is damaged. If none of the above are the issue you can restart the system by disconnecting a 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows drivers to start their vehicle from the distance, allowing them to warm up or cool down the vehicle before they enter. This feature is extremely helpful, especially during cold winter months. The remote start system can be stopped for a variety of reasons, including an inactive coin-battery.
The coin-shaped battery inside the key fob could last between two and four years based on how often it's used, where it was purchased, and the way it is utilized. The date of use is usually printed on the packaging or marked in the manual.
If the key fob stops working after exposure to clean tap water it is recommended to take the battery off, clean the chip with a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it may have caused the chip to become damaged. You will need to replace it.
If you're not sure whether the battery is in good condition you can check the voltage using an instrument connected to the minus and plus terminals. The voltage should be around 12-13 volts, but if it's lower, then the battery needs to be replaced. Alternatively, you can try to reset the on-board computer by disconnecting the battery at 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first, then negative). The engine should start after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible that your receiver module has developed a fault. It's the part that sends out a signal when your key fob turns on. It also acts as an alarm that stops the vehicle from starting without the correct key.
It could be due to various factors, including water damage or just getting old. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water It could be because the keyfob was contaminated with it. In this instance, you'll need to take it out and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry, you can put the battery back into the battery and try again.
If the issue persists, it is a good idea to see the local Peugeot expert or locksmith. They'll be able make use of a diagnostic device to assist in identifying the problem and repair it for you.
The loss of your Peugeot keys to your car is an incredibly stressful experience. However, a trained auto locksmith can solve the issue in only a few minutes. They can cut a new key and programme it to your vehicle, making sure you're back out on the road in the shortest time possible. Find the nearest locksmith.
Faulty Electronic Chip
The electronic chip inside your Peugeot 308 key fob is an crucial component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". In this scenario, the only solution is to replace the key. Auto locksmiths with experience are able to provide this fastest possible time.
The chip inside your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or other causes. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned as soon as possible. You can clean the electronic component using paper towels soaked with isopropyl Alcohol. Then, you need to let the battery completely dry.
Sometimes keys may be inoperable due to radio interference. This is usually caused by other devices use the same frequency as your Peugeot keyfob. This can be caused by bad conditions or objects near to the vehicle. It is recommended to see a Peugeot dealer in the event of this problem.
The Peugeot key fob 207/308 is very delicate and requires a lot of care. It is imperative not to drop or throw the key fob. If you lose something, try to locate it as quickly as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.